Parting out 28 ft Bayliner- Radar Arch, 5 piece walkthru windshield, instrument panel w gauges, captains chair w pedestal, fiberglass swimplatform w ss ladder and supports, bennett trim tabs, aft teak rails, ss bow rail, fuel tank, bow pulpit, interior door, table, stove, sink, toilet, holding tank, etc. can email price and pics 828-242-6434

Runs, but rough. Rebuild or use for many new parts, including 90 amp alternator, starter, injectors, fuel pump. Rebulit MS gear transmission and V-drive.
$300. (Worth it for the alternator or injectors alone...)
Another $100 gets balanced 16"x13 2-blade prop and straight/true 1" stainless shaft.

Continental Yachts Sales is now offering the full line Aquamarine inflatable rafts. check us out at www.continentalyachtssales.com

Looking to sell this boat as a project boat. Has lots of new parts already installed. Needs some construction and fibreglass in the cabin. Needs back wall between aft cabin and engine bay redone, needs aft berth rebuilt.

New parts include: new shafts, new struts, new nibral props, new rudders, new water heater. this is a full load boat and will be a nice cruiser with a little TLC.

Make me an offer

some complete with controls,some not
from $300-$800

12000 lbs capacity great condition Custom fram work to accomidate wide range of boat lengths .

Pics available @ http://www.automax1.com/details.html?VID=1-37l1206125942

EZ Float Boat Trailer MFG. CO. 1946 sling type trailer that was sold new with a 1946 Gar Wood Ensign. Completely restored with new paint, s/s cable and safety chain, new sling, new period wide white wall 16" tires. Asking price of $900 is half of the cost. Have photos to email. Located in Laughlin, NV.

From the windshield to the prop and many parts that are hard to find !

Small unit for sailboat, 2 to 1 reduction came off of atomic 4

80s OMC 800 V-8 Outdrive w good shift cable and ballgear. works well, shift all gears, good oil, gearcase, cavitation plate, skag etc. I can email pics. local pick up or will ship.

Nice galvanized Sailboat Trailer- double axle, 6 leaf springs, galvanized fenders, galvanized rims, buddy bearings, solid frame, tongue jack, winch, complete w 10 height adjustable stands. will conform easy to different keel heights. the trailer overall lenght is 21 ft, it is 94 inches wide outside fender to fender. should be able to handle 3,500 lbs + boats.
Only issue is the tongue has a slight bend. needs to be straighten or replaced. trailer is easily worth $1,000 Local pick up gulfport fl, cellphone 828-242-6434 i can email pics

I have a complete rig for a 28' Chesapeake bugeye, with all masts spars sails and fittings. I have most of the hull fittings as well. I am open to any reasonable offers...I can be reached at macivj@wildblue.net or macivj.john@gmail.com for more information. It could also be use on a meadowlark boat.

Good powerhead, lower unit and misc parts compatible w 70s, 80s and possibly 90s 20, 25, 30, 35, 40 hp Johnson Evinrudes. The powerhead is strong 100 lbs on each cylinder. the lower unit is currently a long shaft. however, it was converted to a longshaft by adding an extention and longer driveshaft. If your driveshaft is good it can work for either a longshaft or shortshaft applications. The gearcase is good, good oil, shifts smoothly into all gears, good skag. The only flaw is a chip out of the cavitation plate. Can sell w or without the prop 10 x 15. also have the cowling - hood, clean carb, fuel system, electrical system, etc. lower pan and midsection w good steering however needs new gear and tiller handle, or will work w cable shifting and throttle. I can email pics. Model number is E35RCRR, Serial number is F0370581 828-242-6434

VELVET DRIVE TRANSMISSION MODEL AS1-71C 1:1 REDUCTION GEAR. WORKED WELL WHEN REMOVED. WHEN FLUID WAS REMOVED IT WAS CLEAN AND CLEAR AND NO SIGNS OF CLUTCH DRAG. THIS TRANSMISSION WAS CLEANED SCRAPED AND PAINTED. $500.00 FORKED RIVER N.J. 08731 FOR QUESTIONS OR SHIPPING QUOTES CALL STAN 609-242-7826

I HAVE A 2000 350 MPI SHORT BLOCK REBUILT WAS A FRESH WATER COOLED BLOCK. POLISHED CRANKSHAFT, NEW CAM BEARINGS, ROD BEARINGS AMD MAIN BEARINGS RERINGED PISTONS. EXCELLENT DROP IN SHORT BLOCK. $1250.00 I,M LOCATED IN Lanoka HARBOR ,NJ. PICK UP ONLY. YOU CAN E-MAIL ME FOR MORE INFO.

Send me an email and I'll reply with a long list of used sailing gear I have available. I have pictures of everything.

3-blade, bronze, stamped 17-1/2" x 16".
Shaft size is 1-1/4" that tapers to 1-1/8". One prop has a slight ding on each blade. $550/cash only.

Complete outdrive (Merc. 215E) in good condition. $1200

Also: 215E Outdrive with good lower end gears. $600

http://delaware.craigslist.org/boa/549287633.html

I have a nice 1937 V8 60 marine motor that I an putting in a Model A car. All marine items on engine need to get in hands of someone who needs them. Waterpumps. Flame arrester, trans., Exhaust manifolds, marine oil pan etc.
John 419 503 1895 make reasonable offer

Chesapeake Bay Bugeye. I have a complete rig for a Chesapeake Bay Bugeye, which includes Sitca? masts booms and bow sprit, sails, running rigging and many brass and galvanized fittings. These parts came from the 28' bugeye Mystic Pearl which I bought in Rhode Island in need of a new hull. The previous owner had disassembled the boat, and could not complete the project. All parts and sails have been in storage for about twenty years, and are in good shape. They would fit well on a new bugeye or a Meadowlark type design. There is also a disassembled one cylinder make and break engine in a box that powered the Mystic Pearl. I have the carved name board as well. Price is negotiable. More information on my site at http://johnmaciver.tripod.com under Wooden Boat Parts

Antique Cabin Cruiser parts. I have all of the fittings for a 1948 flush deck cabin cruiser. This includes the running flat head ford v8 marine engine. Although this boat was used on Narragansett Bay and Newport in Rhode Island, the salt water never got to the insides as the cooling system was an enclosed loop of copper and stainless steel with antifreeze and fresh water coolant. There is a complete drive shaft fitting box and three bladed prop that came with this boat. I have the bronze ports, bollards, and many other fittings as well. I am negotiable on price.

Two trim/tilt cylinders for T.R outdrive
Two trim/tilt cylinders for T.R.S outdrive-one needs new tube(leaks)
one trim/tilt cylinder for one drive good condition
One T.R. prop 19.75 dia.x19 inch pitch
Rideguide flat rack and pinion steering-complete with 15ft. cable and stainless steering wheel
mercruiser power steering pump and fluid cooler
Mercruiser transom plates- inner and outer plates with gimble bearing housing
Complete windshield for 22ft. Searay. welded aluminum frame-good glass.
Pair of exhaust manifolds for mercruiser G.M engine(305 or 350 small block)with center risers
Pair of FORD exhaust manifolds (302 or 351 engine) good condition with rear risers
Carb-dist-starter for 60s johnson 75 h.p. outboard. Dist is belt drive in good condition.

I HAVE A HUGE BUILDING FULL OF USED AND NEW MARINE ENGINES AND PARTS RANGING FROM ---ENGINES, STERNDRIVES,TRANSMISSIONS,V-DRIVES,GASKETS ,SEALS,BEARINGS,CARBS, DIST,HEADS CRANKS, CAMS,STERNDRIVE PARTS I HAVE ALOT OF PARTS I,M TRYING TO GET RID OF TO MAKE ROOM. I,M LOCATED IN CENTRAL NEW JERSEY. MERCRUISER PARTS, CRUSADER PARTS,OMC,DETROIT DIESEL, CUMMINS DIESEL.GIVE US A E-MAIL I,M SURE WE CAN HELP OR AT LEAST STEER YOU IN THE RIGHT WAY

Nice Shoreline galvanized sailboat trailer. Should be compatible w most 17-22 ft boats. Height adjustable for different keels. Adjustable tongue extension. Breakaway for easy launching. Adjustable bunks, one replaced, both recovered, winch w strap, new keel roller, bearing buddies, upright guides, solid frame,
14-inch wheels, tires two years old, nice spare tire. I can email pics. tampa area florida

Parting out late 90s 40hp Suzuki- electric start w trim and tilt. Good control box- NA 12S w engine 8 pin wiring harness and control cables- Cowling, PN- PBT + ABS GF 20. Aluminum Prop S1301. Hitachi Starter-S108-94 B12V 0.6 KW, recoil, oil tank reservior, carb and linkage, flywheel, lower pan,electrical, midsection working trim and tilt, nice!lower unit I can email pics and more info. will sell parts individually or as a package deal.

Extremely clean low hour 2003 Tohatsu 4 stroke outboard for sale.
Looks and runs great.
Located in Fort Lauderdale, Fl.
Asking $1250
Call Jeff
954 383 3468

I have a new standard rotation 25" extra long lower unit that will fit Verado 225, 250, 275 HP outboards.
The part # is 1600-880686A14.
The gear ratio is 1.846:1.
There is a very small paint chip on the bottom of the skeg.
Mercury price $4400.
Asking $2100
Located in Fort Lauderdale, Florida
Call Jeff
954 383 3468

HELLO - I HAVE A NEW 30KW FURUNO RSB0026N SBAND RADAR TRANSCEIVER AND 9 FOOT ANTENNA FOR THE 2135 OR SIMILAR S-BAND FURUNO RADARS -- THE ITEMS ARE NEW IN THE CRATE

I have a lot of boating, fishing, hunting stuff for sale.

Check it all out on my website.

http://home.maine.rr.com/newengland/

Pair of 40 gallon (each) HD welded aluminum fuel tanks. Under gunnel type with fill, vent, and sending units included. Very good condition take-outs from a patrol boat.

for sale or best offer ,supossed to be 200 hrs on new rebuild .

selling complete 270 drive, transom parts, 120 and 125 parts. good 125 block, flywheel, crankshaft, throttle w cable, oil pump, steering helmet, trim pump and misc parts. asheville nc